What Is The Shortest, Abbreviated Version Of The Copy Running-Config Startup-Config Command??

What Is the Shortest, Abbreviated Version of The Copy Running-Config Startup-Config Command??

Answer: The shortest form of the Copy Running-Config Startup-Config command is the copy run start. The short form is easy to write rather than the copy system: r nvram: s. When you need to save the running configuration of the startup file in the NVRAM type the copy run start.

To modify the configuration of RPM at first it is necessary to make the changes in the memory because it can be lost when the system is rebooted. Two forms of the configuration files exit the running configuration which is present in RAM and the startup configuration which is stored in the NVRAM. Let’s see at the condole running configuration to startup configuration for both console graphical user interface based on the following:

Console based:

Different types of the commands are present for the configuration let’s take a look at a few of them such as the:

• Show running-config is used to display the current running configuration. Show
• Startup-config shows the NVRAM configuration.
• Copy running-config startup-config work is to copy the current active NVRAM configuration.
• Erasing startup-config will allow destroying the configuration of the router and you can easily start from scratch.

The guideline for it in the console-based is:

• Launch into privileged mode.
• Display the memory current active config.
• Look at the NRAM stored configuration.
• Copy the NVRAM configuration (active ones).
• Look at the configuration.
• To delete the NVRAM configuration file type the command.
• Again, look at the NVRAM stored configuration.

R1>enable
R1#show                                                running-config
R1#show                                                startup-config
R1#copy                                                 startup-config

R1#show              running-config       startup-config
R1#erase                                                 startup-config
R1#show                                                 startup-config

Graphical user interface:

Instruction for the commands on the GUI based are listed below:

• Choose the R1 devices from the drop-down list, tap on the configuration, and the left navigation is open.
• In the navigation tap on the utility option and then the save Running config to PC.
• For the display the command taps on view > IOS display command.
• In a drop-down list choose the available show commands and tap on show.