How To Route Traffic Between Interfaces On Same Router?
Share
Sign Up to our social questions and Answers Engine to ask questions, answer people’s questions, and connect with other people.
Lost your password? Please enter your email address. You will receive a link and will create a new password via email.
Please briefly explain why you feel this question should be reported.
Please briefly explain why you feel this answer should be reported.
Please briefly explain why you feel this user should be reported.
1. Configure the router with two different IP addresses.
2. Connect the two interfaces to the router.
3. Enable IP routing on the router.
4. Create a static route for each interface pointing to the other.
5. Configure the routing protocol of your choice (if necessary).
6. Configure access control lists (ACLs) to filter traffic between the two interfaces.
7. Verify that the routes are installed and working properly.
1. Create the VLAN and assign it to the interfaces using switchport access vlan command:
– Switch(config)# interface f0/0
– Switch(config-if)# switchport mode access
– Switch(config-if)# switchport access vlan 20
2. Configure the IP addresses for the VLAN interfaces:
– Switch(config)# interface vlan 20
– Switch(config-if)# ip address 192.168.1.1 255.255.255.0
3. Specify the default gateway for the router:
– Switch(config)# ip route 0.0.0.0 0.0.0.0 192.168.1.2
4. Enable routing protocol on the router:
– Switch(config)# router rip
5. Add the networks to be routed to the routing table:
– Switch(config-router)# network 192.168.1.0
6. Finally, verify the routing table with the show ip route command:
– Switch# show ip route