How To Use Hping3 In Kali Linux?
Share
Sign Up to our social questions and Answers Engine to ask questions, answer people’s questions, and connect with other people.
Lost your password? Please enter your email address. You will receive a link and will create a new password via email.
Please briefly explain why you feel this question should be reported.
Please briefly explain why you feel this answer should be reported.
Please briefly explain why you feel this user should be reported.
1. Open a terminal window and type “sudo apt-get install hping3” to install the hping3 package.
2. Once installed, you can use the “hping3” command to run a basic test of your network.
3. To specify a destination like an IP address or hostname, you can use the “-d” switch followed with the target.
4. To perform Port Scanning using hping3, use the “-S -p [port]” switch.
5. To produce verbose output such as sequence numbers and timestamp information, use the “-V” switch.
6. To increase the speed at which packets are sent out, use the “-i uX” switch where X is the interval in microseconds.
7. To set the size of the packets, use the “-s XX” switch where XX is the packet size in bytes.
8. To specify the TTL values, use the “-t XX” switch where XX is the TTL value.
9. To change the TCP flag values, use the “-F [TCPFlag]” switch.
10. To send a series of SYN packets and observe the response, use the “–tcpsyn” switch.