What Command Would You Use To Only See The Ospf Routes In The Routing Table?
Share
Sign Up to our social questions and Answers Engine to ask questions, answer people’s questions, and connect with other people.
Lost your password? Please enter your email address. You will receive a link and will create a new password via email.
Please briefly explain why you feel this question should be reported.
Please briefly explain why you feel this answer should be reported.
Please briefly explain why you feel this user should be reported.
What Command Would You Use to Only See the OSPF Routes in The Routing Table?
Answer: The command which we would use to just see the OSPF routes in the routing table is the show ip route [ospf | subnet mask].
The commands of the OSPF network are used to compare the IP addresses and they are configured on the interfaces only the match IP addresses in the OSPF procedure. to manage the bits in an octet and to make sure there are the same the OSPF network uses the wildcard masks. The command show ip OSPF neighbor is for to identify the information of the neighborship of the OSPF where the interface is a part apart from it the state, the neighbors address and its router ID.in order to select the router ID, the router has to move to a procedure, and when the router ID found the process stops. The process is that if any value configured through a command router-id greater the configured IPv4 address of the loopback interface, then the greater configured IPv4 addresses of the physical interface.
The show ip OSPF interface is used to display that which interfaces are allowed in the process of OSPF. Only the router if the OSPF is configured in multiple areas known as Area Border Router. To display the OSPF neighborship the command which is used is show ip OSPF neighbor. For the database of the OSPF, the command which is used is to show the ip OSPF database. The show the OSPF routes in the existing routing table the command is shown ip route.to determine the configured area the command which is used is to show ip protocols and show ip OSPF interface.