How To Enable Layer 3 Switch For Routing?
Share
Sign Up to our social questions and Answers Engine to ask questions, answer people’s questions, and connect with other people.
Lost your password? Please enter your email address. You will receive a link and will create a new password via email.
Please briefly explain why you feel this question should be reported.
Please briefly explain why you feel this answer should be reported.
Please briefly explain why you feel this user should be reported.
1. Log into the switch using administrator credentials.
2. Navigate to the “Routing” or “Layer 3” section in the router configuration page.
3. Enable layer 3 routing by checking the enable box for layer 3 routing.
4. Specify the desired IP address, subnet mask and default gateway.
5. Configure static routing by specifying the source and destination IP addresses and the corresponding next hop routers.
6. Configure dynamic routing protocols such as RIP and OSPF.
7. Specify the network range on which the routing protocol will be enabled.
8. Save the changes.
9. Verify that the routing is working by pinging devices on different networks.