To open the DHCP console from the Command Prompt, type “mmc”. This will open up the Microsoft Management Console. In the left pane of the MMC, click File > Add/Remove Snap–in. Select the DHCP option, then click the Add button. Once you add the DHCP snap–in, you will be able to view and configure the DHCP settings.

1. Choose the ideal spot and secure the mount: First, you should choose a spot in your home, office, or other building that is ideal for the access point. This spot should have good coverage, with minimal interference from walls, furniture, and other obstacles. Once you have chosen the spot, you will need to install the mount for the access point. Depending on the size of your access point, this can involve drilling into the wall, surface–mounting, or installing an existing bracket.

2. Connect power and update firmware: You will need to connect the access point to a power source, either through a wall outlet or through a PoE switch. Once power is connected, the access point may need to update its firmware. This can be done through a web interface or with a special utility application.

3. Configure radios: The access point will need to be configured so that it can send and receive signals. This involves setting up the basic settings (SSID, security type, etc.) as well as any advanced parameters (channel width, transmit power, etc.).

4. Fine–tune antenna: Finally, you should fine–tune the antenna on the access point to ensure that it can maximize the signal range and strength in the area. This is usually done by adjusting the tilt and orientation of the antenna.

1. Changing router IP address

a. Login to your router.

b. Look for the option that says “LAN” or “Local Area Network.”

c. Select it and then look for a sub–option that says “IP Address.”

d. Enter the IP address you want to use and make sure it‘s not in use by another computer or device on your network.

e. Save the settings and reboot your router.

2. Changing computer IP address

a. Open the Control Panel.

b. Go to the “Network and Internet” section.

c. Select the “Network and Sharing Center” option.

d. Select “Change adapter settings.”

e. Select the adapter you‘re using (Ethernet or Wi–Fi). f. Right–click on the adapter and select “Properties.”

g. Select the “Network” tab.

h. Enter the IP address you want to use and make sure it‘s not in use by another computer or device on your network.

i. Select the “OK” button to save the settings.

1. Connect the power cord to the modem and plug it into a wall outlet.

2. Connect an Ethernet cable from the modem to the internet port on the router.

3. Connect the power cord to the router and plug it into a wall outlet.

4. Turn on the router and wait for it to boot up.

5. Access the settings of the router through a web browser.

6. Enter the username and password for the router to view the available settings.

7. Select an SSID (wireless network name) and enter a passphrase for the wireless network security.

8. Save the settings and you are now ready to use your router and modem.

Protocol is a set of rules that defines how two or more computers communicate with each other. These rules determine the format, timing and sequence of data exchange. Protocols can be used to communicate between different kinds of computers, and also between computers and other kinds of devices, like printers and scanners.