What Is Different Between Ipv6 Routing Table Entries Compared To Ipv4 Routing Table Entries?

What is different between IPv6 routing table entries compared to IPv4 routing table entries?

The data packets over the internet with the help of the standard protocol is determined by the routing table. They are themselves the set of rules in the table format. Devices that use the protocol are associated with the routing table.

The IP has two forms one is the IPV6 and the other one is IPV4 these two also use the routing table that’s why there is a difference between their entries in the routing table. A question that has been asked is: What is different between IPv6 routing table entries compared to IPv4 routing table entries? The answer to the question is given below in the topic, so read the article to the end to get complete knowledge!

The contrast between IP6 and IPV4 

People are inquisitive to know the difference between IPV6 and IPV4 because they both are the protocols type. To fulfill the curiosity, we have mentioned some of the points in comparison of them in the following:

Address:

IPV4 is 32 bits long and the address consists of the network part and the host part. The classes are also defined such as A, B, C, D and E .in short, the total IPV4 addresses are approx. 4 294 967 296.

In IPV6 it is 128 bit long, in which 64 bits are for network and 64 bits id for the host part of the address. The host is obtained from the MAC address and it is complicated than IPV4.

Configuration:

Before the communication of the IPV4 with the system, the configuration of the newly installed system is obtained and because of this the IP address and the routes are allocated.

In IPV6 the configuration is not necessary. The IP is used with an ethernet adapter, IPV6 has the auto-configuration. But the manual configuration is also possible and the system communicates with the systems which are either local and remote.

Dynamic host configuration protocol:

DHCP is to automatically obtains the IP address and various other configuration information. The IBM I provide assistance of DNCP server in IPV4.

In IPV6 the IBM i does not give the assistance of DHCP administration. Instead, the ISC DHCP server administration is used in IPV6.

The header of IP:

In IPV4 the length of the header depends on the available IP option, and it lies between 20 to 60 bytes.

In IPV6 the header length is fixed which is 40 bytes, the header of IPV6 is easier than the IPV4.

What is different between IPv6 routing table entries compared to IPv4 routing table entries?

1. IPV6 has wide route entries which are not in IPV4.
2. IPV4 entries are based on the short method while the UPV4 uses the long one.
3. IPV4 does use a dynamic route as compared to IPV4.
4. By design, IPv6 is classless, so all routes are effectively Layer 1 end routes.

Option D is correct that IPV6 is classless by design that’s why all routes use the level 1 routes ultimately. The link-local routing is used for the IPV4 and IPV6.both use the longest method for entries.