What Is The Shortest, Abbreviated Version Of The Copy Running-Config Startup-Config Command?

What is the shortest form of the copy running-config startup-config command?

The abbreviation of the copy running-config startup-config command is “copy run start” the short forms are used to save the time of the user. Also, you don’t have to type the large syntax you can attain the task with a shorter form. Sometimes you can also type cop r s  even shorter than the previous one. The command is for the backup of the running and configured NVRAM file.

The command also helps for the surety of any change in the system, when the system reboot or shut down. The Effect of the command is that when the files are moving from RAM TO NVRAM the content of the NVRAM will change.

What is the process after the command is executed?

After the copy running-config, the startup-config command executes then the file is going to store in the non-volatile memory which is known as the NVROM. The command helps the copy of the file from RAM to NVRAM. And for the execution of the command properly the file must need to reside in the RAM beforehand.

If the Router has no configuration and no config into the RAM then you try to execute the command copy startup-config running-config command then the error message will display on your screen such as the NVRAM configs is not appropriate or present. The file can also be stored on the TFTP protocol to store in the NVRAM.

If the router starts to boot without the configuration then the next step is trying to find it in the TFTP server and also the server has o configuration which is suitable for the router then it will try to set the dialog and invoke the user to give the configuration for start or input.

The configuration for the startup is not stored in the RAM .it is only in place for the time being unless the configuration will transfer to the NVRAM or TFTP server in the process of booting. The configuration also does not share with ROM. It has the code for bootstrap and the in the flash memory the IOS images are placed.

Guides to using the command:

During the process the manual configuration issue of the command for saving the files from RAM to flash. The guides are in the following:

• Change the password right after the PICPS finishes the installation.
• Boot the PICOS.
• Try to pick the install/uninstall option.
• Set the command L2 OR L3 because the commit command needs to execute before the save command.
• Set the OVS and Crossflow commands.

For the configuration, the two commands use it is either the save config or copy command. In the mode of the L2 OR L3, the command is executed in such a way

Copy running-config startup-config

In a simple form, the command is to store the running-config file from RAM to NVRAM and it has its abbreviation which works the same which is copy run start or cop r s.